Thursday, June 13, 2013

Configuring NFSv4 on FreeBSD

After much monkeying around, I finally have NFSv4 running on FreeBSD. Since there seems to be a lack of documentation specifically for NFSv4, here is my take on it. The nfsv4 man page does tell you what you need to know in order to get a basic client and server running, is was clear to me only after I had it working. In my setup, my server is running FreeBSD 9.1, and my client runs 9.0.

Server Configuration

  1. In /etc/rc.conf, add the following lines

    nfs_server_enable="YES"
    nfsv4_server_enable="YES"
    nfsuserd_enable="YES"

  2. Start the NFS daemons by running

    /etc/rc.d/nfsd start

  3. Open /etc/exports in your preferred editor. Add a "V4:" line to the file, specifying the root of your NFSv4 tree. There are two choices at this point. Option 1 is to place your NFSv4 root at a location other than the root of the server filesystem. With this option, you can create an arbitrary NFS tree for clients to attach to, independent of how data is actually situated on the filesystem(s). Nullfs mounts may be used to include outside directories in the NFS root. Option 2 is to make the NFSv4 root the actual root of the system. This preserves the behavior of old NFS implementations. Regardless of where you put your V4 root, you must also add export lines, in the same style as NFSv3. The exports man page can be helpful here, and discusses the security implications of using NFSv4.

    # Option 1
    V4: /nfsv4 -network=10.0.0.0 -mask=255.255.255.192
    /nfsv4/ports -maproot=root: -network=10.0.0.0 -mask=255.255.255.192
    
    # Option 2
    V4: / -network=10.0.0.0 -mask=255.255.255.192
    /usr/pxe/ports -maproot=root: -network=10.0.0.0 -mask=255.255.255.192

  4. Reload the exports file by signalling mountd

    killall -HUP mountd
    
    

Client Configuration

Clients should now be able to mount the exported filesystem using the following commands, corresponding to the NFSv4 root options specified above. Notice that with option 1, the remote path omits the /nfsv4 prefix of the server.

# Option 1
mount -t nfs -o nfsv4 server:/ports /mnt

# Option 2
mount -t nfs -o nfsv4 server:/usr/pxe/ports /mnt

Errors

If you get the following error when trying to mount from the client, don't be fooled:

mount_nfs: /mnt, : No such file or directory

This may indicate that you have misspelled the remote path in your mount command. It may also indicate that you have an error in your exports file, or that your exports file is not configured the way you think it is. Go back and read step 3 of the Server Configuration.

1 comment: